Contents
- I. Module Introduction
- II. Introduction to Main Chips
- 2.1 Chip Overview
- 2.2 Pin Definition
- 2.3 Functional Block Diagram
- 2.4 Performance Parameters
- 2.5 Reference Circuit
- 2.6 Chip Configuration
- 2.7 Communication Interfaces and Related Protocols
- 2.8 PCB Routing Precautions
- III. Circuit Engineering
- 3.1 Circuit Source Engineering
- 3.2 Module Usage Instructions
- 3.3 Application Experiment
- IV. Drivers
- 5. BOM & Recommended Alternative Parts
- VI. Revision History
- 7. Relevant Materials
- 7.1 Chip Datasheet
- 7.2 Unique Icons for PCB Silk Screen


I. Module Introduction
PH2.0-3P to Grove Adapter Board is an interface conversion adapter module that enables PH2.0-3P interface and Grove interface to realize signal and power transfer, and is compatible with the water flow bubble detector MWFD sensor; the module is equipped with LDO voltage regulator circuit, power filtering and power indicator, supports 3.3V power supply, can stably output the sensor signal to the main control end through the adapter board, and provides a convenient signal and power transfer solution for devices with different interface standards.
II. Introduction to Main Chips
2.1 Chip Overview
None.
2.2 Pin Definition


2.3 Functional Block Diagram
None.
2.4 Performance Parameters
None.
2.5 Reference Circuit
None.
2.6 Chip Configuration
None.
2.7 Communication Interfaces and Related Protocols
None.
2.8 PCB Routing Precautions
None.
III. Circuit Engineering
3.1 Circuit Source Engineering
To obtain the source code of the circuit, please follow the official account [Freak Embedded]
3.2 Module Usage Instructions
The schematic diagram of this module is shown below:
SCH_Schematic1_PH2.0-3P to Grove Adapter Board_v1.0.0_2026-05-07.pdf 2.2 MB

This module adopts digital input DOUT: Liquid flows through the sensor tube, the sensor detects the change of the measured object in the tube and outputs the corresponding status. It outputs a low level when liquid is detected, and a high level when bubbles (liquid shortage) are detected; it can be directly connected to the main control GPIO port, and outputs a binary signal (high/low) corresponding to the sensor detection status, which is suitable for scenarios such as trigger detection and status indication.
3.3 Application Experiment
This module is a adapter board for Minya Sensor - Water Flow Bubble Detector MWFD. For specific usage, please refer to:
Water Flow Bubble Detector MWFD
IV. Drivers
None
5. BOM & Recommended Alternative Parts
None.
VI. Revision History
Document Version | Date Modified | Modifier | Modify Content |
v1.0 | 2026-05-07 | Ling Gaoxing | Initialize the document |
v1.1 | 2026-06-05 | Xin Ruili | Create an open version of the document based on the internal document version v1.1. |
7. Relevant Materials
7.1 Chip Datasheet
MWFD Water Flow Bubble Detector Product Manual-MinYuan202603.pdf 564 KB
7.2 Unique Icons for PCB Silk Screen
